Electric High Power

High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston

High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston
High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston

High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston

This is a powerful 12V DC (direct current) actuator designed for heavy loads, low noise and high waterproof applications. Each actuator can provide up to.

Of pushing or pulling force at the rated voltage. The no-load travel speed at 12V is 5mm/s while at the full rated load the travel rate is 3mm/s.

This model is currently stocked in different stroke lengths (travel distances) of 100mm (4"), 200mm (8"), 300mm (12"), 400mm (16"). Motor: The motor is a 12V DC. The motors shaft powers a worm. Plastic-enclosed steel motor housing, with toughened plastic gearbox surround. The housing cannot be opened. Gear unit: The worm gear is directly powered by the motor shaft which moves a trapezoidal sliding spindle. Linear unit: The actuator extends and retracts the inner tube.

The linear unit is surrounded and protected by the outer tube. The inner tube of the actuator is connected to the spindle with a lead screw nut.

Wires to connect actuator to power supply or to an external control. The actuator comes with a 1.5m PVC insulated lead as standard (black external sleeve with two internal cores, one brown and one blue) with uncovered lead ends.

20% this is the maximum proportion of time that the actuator may be in operation for, up to 2minutes during any continuous stretch. The duty cycle should be reduced below 10% for average loads >2000N.

Aluminum-Alloy outer tube and inner tube, plastic-enclosed steel motor housing, with toughened plastic gearbox surround. Zinc plated steel front and rear brackets. Enclosure rated to IP66, suitable for washing and short-term water exposure.

If using outdoors shield actuator from direct rain. Installed internally at ends of travel (fixed-position). One at the end of the cylindrical piston rod, the other towards the rear of the gearbox housing. Both mounting points feature vertical slots to enable a variety of mounting methods. (with standard lead, no connector).

The distance from the front to rear mounting hole centers when the actuator is retracted. Note: Please be aware that there may some variation in the operating performance from actuator to actuator, as a rule-of-thumb allow for a 5% difference above/below the given values. To change the direction of travel simply swap the polarity of the DC power source to the two actuator leads.

By varying the input voltage between 0-12V DC it is possible to control the speed of the actuator. Reducing the voltage will also reduce load capacity (for example at 6V the actuator will have roughly half of the maximum load capacity at 12V).

This actuator is designed primarily for compression loads, it will typically work OK in tension, up to the same rated maximum load, but can be more susceptible to damage from overloading. Shock loads through the mounting points should be avoided. Experienced users who wish to extract greater power from the actuator (at their own risk) should abide by a practical operation ceiling of 18V, above which the motor, diodes and limit switches of the actuator would be significantly more likely to fail.

Be aware that the current draw will be greater if the actuator is run at above 12V DC and the duty cycle should be reduced to help avoid over-heating. Ensure that the control hardware and power source are capable of providing sufficient current for the loads you expect the actuator to experience. We cannot be held liable for damage caused to connected hardware due to inappropriate hardware selection. The item "High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston" is in sale since Thursday, June 13, 2019.

This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Rotary & Linear Motion\Linear Actuators". The seller is "openboxtv" and is located in SALFORD. This item can be shipped to United Kingdom, Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Australia, United States, Bahrain, Canada, Brazil, Japan, New Zealand, Israel, Hong Kong, Norway, Indonesia, Malaysia, Mexico, Singapore, South Korea, Switzerland, Taiwan, Thailand, Bangladesh, Belize, Bolivia, Brunei darussalam, Dominica, Ecuador, Egypt, Guernsey, Gibraltar, Guadeloupe, Grenada, French guiana, Iceland, Jersey, Cambodia, Saint kitts and nevis, Liechtenstein, Macao, Monaco, Martinique, Nicaragua, Pakistan, Peru, Paraguay, Turks and caicos islands, Aruba, Saudi arabia, United arab emirates, Chile, Bahamas, Costa rica, Dominican republic, Guatemala, Honduras, Jamaica, Kuwait, Panama, Philippines, Qatar, El salvador, Trinidad and tobago, Uruguay, Viet nam, Antigua and barbuda, Bermuda, Barbados, Cayman islands, Jordan, Saint lucia, Sri lanka, Maldives, Oman, Reunion, South africa, Ukraine, Colombia, Montserrat.

  • Modified Item: No
  • Country/Region of Manufacture: China
  • Unit Quantity: 1
  • MPN: LMW4D-6000N-12v
  • Unit Type: kg
  • Brand: Linear Robotics
  • Actuation Force: 4000N
  • Voltage: 12V DC


High Power 12V DC Linear Actuator, 4000N/407kg Force, Low Noise, Electric Piston