Temp of blade: instantly heated to 500 degree in few seconds. Power cord length: 3 meters. Machine size: 23x15.5x16cm (battery parts). After confirming tool cooling, unscrew the nut.The two knife blades are inserted into the two legs knife, tighten. Make sure the blade and knife holder full contact. Have been properly installed, the blade will not be heated. Avoid direct contact with the two knife leads to a short circuit. The temperature control knob to a smaller location, the blade on the cutting object, and then press the switch. It is recommended to test the waste. When cutting is best to keep the temperature and speed of harmonization. If you smoke too much, it may be because the cutting blade speed is too slow or the temperature is too high.
This may cause irregular cutting path, not flat, this situation, you can lower the temperature or the cutting blade intermittently release the switch. When finished cutting the distance 3-5CM, release the switch. When cutting, the exposed portion of the blade should not be more than 2 cm, if the exposed portion is too long, the blade may be bent due to overheating.Use wire brush to clean the blades. Always use this tool in a ventilated environment.
Do not burn residual debris on the blade, otherwise the blade will bend. Do not dry long blade, so the blade deformation. Please handle blade after blade cooling, in order to avoid accidental injury. Do not make a red-hot blade without cutting materials.
The item "220V High-power Electric Knife Foam Cutter Hot wire foam cutting Machine Tool" is in sale since Monday, January 11, 2016. This item is in the category "Crafts\Multi-Purpose Craft Supplies\Crafting Pieces\Styrofoam Forms". The seller is "artprintingstore" and is located in Guangzhou,Guangdong. This item can be shipped worldwide.